aandrei wrote: > > I think there might be a minor bug in the K3 firmware when switching > antennas in Diversity mode. > > Context: > > Have 2 antennas, connected to Main and Aux, that even on the same > frequency give you signals which are different enough that you can tell > the difference. > In normal (non-diversity mode) make sure you have both receiver and > sub-receiver antennas set to Main. > Switch to diversity mode. > Click B-Select > Set sub-receiver antenna to Aux. > Click B-Select >
Adi I'm away from my shack to check your question but here's a little tip for you. It's not necessary to go into BSET to change the Sub RX antenna. If you HOLD RX ANT, it will toggle the Sub RX antenna between Main and Aux...just like TAPping RX ANT will toggle the Main antenna between ANT1 and RX ANT. I seldom use BSET and look forward to the dawn of the K4 when it should not be necessary at all! (i.e. all Sub RX settings will be visible on a large display at all times). :-) I don't know if you've discovered a bug but may check later when I'm at the rig. 73, Bill -- View this message in context: http://elecraft.365791.n2.nabble.com/Relay-noises-tp6298266p6299361.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
