Forgot to finish a sentence.... On Sat, Apr 23, 2011 at 10:00 AM, Guy Olinger K2AV <[email protected]> wrote: > When you are in diversity, you are using many of the settings from RX > A in RX B. When you hit B set, you will also find that RX B uses the > VFO B frequency, which will cause you to not hear the RX A frequency > when for example fiddling with the NR or NB to see if they help > reception. You need to do an A->B first. > > It is clear that going to BSET drops out of diversity until you are > finished with it. I'm not sure I would call that a bug, as once you > know about it, you do the workaround easily enough, but it would be > nice if it didn't do that. You have to drop the BSET to return to > diversity phase lock. > > Dropping the frequency if you've been tuning around, particularly if > all you want to do BSET is look at the B S-meter, is a pain in the > patooey. None of the cheep fixes work (like move A->B as part of > BSET) because VFO B contents may be intentional. > > If that was done as a quick way to drop out and listen elsewhere in > diversity, I'm annoyed, and would want that behavior as an option that > I could turn off. > > 73, Guy. > > On Sat, Apr 23, 2011 at 7:38 AM, Bill W4ZV <[email protected]> wrote: >> >> aandrei wrote: >>> >>> I think there might be a minor bug in the K3 firmware when switching >>> antennas in Diversity mode. >>> >>> Context: >>> >>> Have 2 antennas, connected to Main and Aux, that even on the same >>> frequency give you signals which are different enough that you can tell >>> the difference. >>> In normal (non-diversity mode) make sure you have both receiver and >>> sub-receiver antennas set to Main. >>> Switch to diversity mode. >>> Click B-Select >>> Set sub-receiver antenna to Aux. >>> Click B-Select >>> >> >> Adi I'm away from my shack to check your question but here's a little tip >> for you. It's not necessary to go into BSET to change the Sub RX antenna. >> If you HOLD RX ANT, it will toggle the Sub RX antenna between Main and >> Aux...just like TAPping RX ANT will toggle the Main antenna between ANT1 and >> RX ANT. >> >> I seldom use BSET and look forward to the dawn of the K4 when it should not >> be necessary at all! (i.e. all Sub RX settings will be visible on a large >> display at all times). :-) >> >> I don't know if you've discovered a bug but may check later when I'm at the >> rig. >> >> 73, Bill >> >> >> -- >> View this message in context: >> http://elecraft.365791.n2.nabble.com/Relay-noises-tp6298266p6299361.html >> Sent from the Elecraft mailing list archive at Nabble.com. >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
