Hi Matt,
If you have another rig that can receive at 8.215Mhz, connect it to
the K3's IF out, and you should hear the same signal that you hear
from the K3.
73,
~iain / N6ML
On Sun, Mar 4, 2012 at 10:36 AM, Matt Murphy <[email protected]> wrote:
> I'm wondering if anyone could advise on the best way to verify that the
> K3's IF output is present and working properly. I have connected an LP-PAN
> unit and I have two hypotheses about what might be wrong, one is that there
> is no IF output and the other is that something is wrong with the LP-PAN.
> I verified that the TMP cable is plugged in properly into the RF board and
> KXV3 but don't have any other devices which consume the IF output so I
> can't be sure it's actually operating properly.
>
> Suggestions would be much appreciated.
>
> 73,
> Matt NQ6N
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
