The easiest way is to hook up a receiver tuned to 8.215 MHz to the K3's IF output. Signals should be almost as strong on the receiver as they are on the K3.
Alan N1AL On Sun, 2012-03-04 at 10:36 -0800, Matt Murphy wrote: > I'm wondering if anyone could advise on the best way to verify that the > K3's IF output is present and working properly. I have connected an LP-PAN > unit and I have two hypotheses about what might be wrong, one is that there > is no IF output and the other is that something is wrong with the LP-PAN. > I verified that the TMP cable is plugged in properly into the RF board and > KXV3 but don't have any other devices which consume the IF output so I > can't be sure it's actually operating properly. > > Suggestions would be much appreciated. > > 73, > Matt NQ6N > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
