Jim, If you are tired of spinning your K3 VFO from one end of the band to the other, and also switching modes when you get there, you might consider this suggestion. On each band, you can easily set up 4 different go-to frequencies using the four (M1-4) memory buttons. On each band and for each of 4 modes, tune VFO-A to the desired frequency, set both VFOs to the same frequency (tap A>B twice), select a mode, and optimize your filter settings.
To store these settings in one of the four memories: Tap the V>M button once. Tap the M# (1-4) button that you want to use for that frequency/mode. Do this for each of four mode/frequency/filter combinations on each of the bands from 160M to 6M. On each band I use M1 for CW, M2 for SSB, M3 for PSK31 and M4 for RTTY. On 30M, where SSB is not allowed, I substituted the WSPR frequency/mode info for the M3 memory. You can make changes based on your mode/frequency preferences. To quickly switch to one of the M1-4 memories: Tap the M>V button once. Tape the M# (1-4) once. This will allow you to quickly move you between frequencies and modes on each band. I hope that you find this info useful. 73, Rich - K1HTV = = = -----Original Message----- From: bill ny9h [mailto:[email protected]] Sent: Sunday, March 04, 2012 12:20 PM To: Jim McDonald; [email protected] Subject: Re: [Elecraft] K3 feature request - auto-changing tuning rate i do tire of spinning that know from ssb to cw..... what's the harm if it can be shut off?? pse ...when you have some spare time wayne.... bill ny9h/3 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
