Jim,
Why are you re-doing the macro in a continuous loop?
More specific, why do you have the SWH45 and SWH47 included in the macro.
If you assign the first macro to PF1, and then initiate it with a hold
of PF1. it will execute the MD3, then BW0040, but when it sees the
SWH45, it will start all over again, and will never end.
I am not certain how it could be working right now.
73,
Don W3FPR
On 2/16/2013 2:12 PM, Jim Leder (Hotmail) wrote:
The 2 macros I use work OK since I reloaded the firmware. I tried so
many different, fancy things prior to getting messed up, I'm not sure
what they were now, but it was a lot. That's when I attempted to go
back to what I knew was OK, but they didn't work either. That's when I
got desperate and as a last resort, reloaded the 4.60 firmware.
Here are the two ORIGINAL macros that now work once again:
CW MD3;BW0040;SWH45;MN255; /* PF1 hold */
FSK MD6;DT2;BW0050;SWH47;MN255; /* PF2 hold */
Seems something in the firmware got out of sorts by my screwing around
with those two macros, but I don't know how.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
