I had to remove that standoff to get the shield out (and back in) so I could cut a notch in the shield for the two meter antenna cable
________________________________ From: Gary W. Hvizdak <[email protected]> To: [email protected]; [email protected] Sent: Saturday, May 3, 2014 8:04 PM Subject: Re: [Elecraft] K3 Kit Wisdom Sat May 3 19:24:08 EDT 2014 Hank K7HP writes ... John - One other small step for K3 assemblers that I felt should be done earlier is on page 58 of the K3 assembly manual "KNB3 installation procedure" My note to myself was the standoff for the noise blanker should be done BEFORE the KPA3 shield step or even earlier - it was a dog for me to get that standoff mounted after the KPA3 shield was in place. --- - - - --- I thought so at first as well but after studying the situation, realized that it had to be done in the order specified. (I don't recall why.) 73, Gary KI4GGX K3 #2724 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
