On 5/8/2014 1:48 PM, Greg Leber wrote:
I hooked it to a dummy load and this is what I found.
A few things to check. What were you using for a wattmeter? What is the
full scale reading on the range you were using? If there is an ATU, was
it in bypass? What coax are you using between the radio and the dummy
load? Where did you get it -- what I'm getting at is that there's a lot
of junk coax around. :)
Also, consider that there may be an issue in the AL1200 input circuit.
How much power does it take to drive the AL1200? Most amps in that
power range get to full output with 40-50 watts. That's what my
1980-vintage Ten Tec Titans need. A pair of 3CX800A7s.
73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
