You should see what happens when you hit it with 200 watts !!
73, Dick, W1KSZ
On 5/8/2014 6:39 PM, GRANT YOUNGMAN wrote:
The AL-1200 needs at least 100 watts input to reach a full 1500 watts out.
It’s an excellent, virtually indestructable amp, but a 100 watt output exciter
is marginal for it.
Grant NQ5T
On May 8, 2014, at 4:12 PM, Phil Wheeler <[email protected]> wrote:
Assuming the list below is the K3 barefoot into a dummy load (and not the
AL1200 driven by the K3), how much drive does the AL1200 specify?
Phil w7ox
On 5/8/14, 1:48 PM, Greg Leber wrote:
Today when I tried to drive my AL1200 amp I found the K3 was not putting
out enough power. It drives the KPA500 fine but that only requires about
20W. I hooked it to a dummy load and this is what I found.
10m 66w
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
