Are you doing the TX Calibration with a dummy load?
________________________________ From: Greg Leber <[email protected]> To: Elecraft <[email protected]> Sent: Thursday, May 8, 2014 4:48 PM Subject: [Elecraft] K3-100 low power output Today when I tried to drive my AL1200 amp I found the K3 was not putting out enough power. It drives the KPA500 fine but that only requires about 20W. I hooked it to a dummy load and this is what I found. 10m 66w 12m 103w 15m 80w 17m 88w 20m 94w 30m 106w 40m95w 80m 87w 160m 91w I did the Xmit gain calibration using the utility and I have no error messages. The finals must be OK because I have over 100w on two of the bands. Do anyone have any Idea what's going on here? Greg (K9ON) -- "Life is hard; is's harder if you're stupid." John Wayne ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
