Seems really odd to use USB for data. DATA A is just USB with a data-friendly preset, right?
Also, which firmware rev they are using. There seem to be situations where the microcontroller loses its tiny electronic mind and needs a reset. Early on, I would lose RX when going BAND+/-, then it would come back if I did that a few more times. I could not figure out way to reproduce the behavior. An EEINIT and config reload fixed it. wunder K6WRU On May 24, 2014, at 9:00 AM, Phil Wheeler <[email protected]> wrote: > They may not be using the DATA mode; many folks use USB for PSK31 -- but then > compression can be an issue. > > Come to think of it, it would be good to know just how they are set up -- > which mode, which modem (e.g., SignaLink usb), etc. > > Phil w7ox > > On 5/24/14, 8:37 AM, Walter Underwood wrote: >> Compression should not matter, because that is disabled in DATA A mode. >> >> I'd save the config, EEINIT, and reload. If that doesn't fix it, ask >> [email protected] >> >> wunder >> K6WRU >> http://observer.wunderwood.org/ >> >> On May 24, 2014, at 6:48 AM, Don Wilhelm <[email protected]> wrote: >> >>> Julie, >>> >>> Check to be certain Compression is set to zero. >>> If it was not set to zero, you should also re-adjust the audio level >>> (either with the computer soundcard level settings or the KX3 Mic Gain). >>> >>> 73, >>> Don W3FPR >>> >>> On 5/24/2014 9:28 AM, [email protected] wrote: >>>> Hello to all! Our KX3 that Larry uses for PSK has mysteriously developed >>>> an unstable ALC bar setting. >>>> If we use the mic gain to set it for 4 bars while transmitting, then on >>>> the next transmission, without our having touched any controls, it goes >>>> back up to 6 or 7 bars. >>>> Any ideas what could have changed to make this happen? >>>> We must have inadvertently changed something but I don't know what. >>>> THANKS! >>>> Julie KT4JR and Larry K4MWE >>>> ___________________________ > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] -- Walter Underwood [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
