The KPA is still set for RADIO= K3, right? Shortly after power up, the KPA will send its on state to the K3 using the Auxbus, but only if it is told the radio is a K3. The symptom is that this is not being received by the K3. The logical conclusion is that something is blocking it. Nothing messed up on pin 2 of the AUX cable, right?
I don't remember if the K3 must be told about the KPA (don't think so, but that would have been long ago...), but if so make sure of that setting. I'll research this a bit more when I get back to my info system, maybe an hour... 73, JackB, W6FB Sent from my iPhone > On Dec 22, 2014, at 7:16 AM, Sam Morgan <[email protected]> wrote: > > That was my thought Jack. I just re re checked, no bent pins, and both ends > firmly reseated. no joy :-( > >> On 12/22/2014 8:43 AM, Jack Brindle wrote: >> Sam; >> >> It sounds like the Auxbus is no longer connected from the KPA to the >> KAT/ K3. Make sure the 15 pin connector is solidly connected on both >> sides at both the KPA and the KAT. Also, make sure no pins in that >> cable are bent. >> >> - JackB, W6FB > > > > -- > GB & 73 > K5OAI > Sam Morgan > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
