Carl,
I figure you are using the K3 LINE IN jack, and when you used it on the
KX3, you used the MIC jack.
The Line In needs a much larger audio signal than the mic level that
your SignaLink is providing.
There is a jumper you can change in the SL box to increase the audio
output level - look for it in the SL manual.
73,
Don W3FPR
On 6/4/2015 3:27 PM, Carl Jón Denbow wrote:
I've been trying to set up my data modes using a SignaLink USB, which
I've used with good results with my KX3, with my K3. I do have the
correct K3 jumper board in the SL. I also have the SignaLink supplied
cables hooked up correctly. I can monitor digital signals just fine.
I can not get any TX audio actually transmitted, though Windows
indicates that the USB Codec Speaker is getting plenty of audio on
TX. I've tried to use the Test TX DATA routine within the K3 and get
no ALC even when Windows indicates that that line has full bore
audio. I'm probably doing something rather simple wrong here, but I
can't for the life of me figure out what it might be. In terms of
experience, I'm an old hand at digital modes having run them on
numerous rigs, with various computers and external sound card
combinations over a number of years. I'm, however, very new to the K3
as I just purchased it used at Dayton this year, and I'm just now
trying to hook it up for digital modes. Thanks for any help you can
give. 73 de Carl, N8VZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
