Carl,
You should be in DATA mode - specifically the DATA A submode on the K3.
Do not use SSB mode, even though it will work, that just "muddies the
waters".
For that mode, do not set MIC+LINE on in the menu - set LINE IN only.
This is a per mode setting, so if you want to use MIC+LINE for voice
modes, it will stay.
With LINE IN set as the input, the gain adjustment is the MIC Gain control.
You will likely find the best result if you set the SignaLink for high
level output. That will give you better control with the LINE IN gain
in the K3 set for something mid-range rather then using a high setting.
73,
Don W3FPR
On 6/4/2015 5:33 PM, Carl Jón Denbow wrote:
<<<Which digital mode did you select? >>>
JT9
<<<Are you using mike input or line in input? >>>
Line
<<<If line in, have you adjusted the K3 line in level. >>>
I guess I need instructions about how to do this. Please see earlier
post I made about my inability to find proper menu item.
<<<Make sure you have selected the correct audio input source in the
K3 menu. >>>
Perhaps I need instruction about this too, though I set MIC+LIN to ON.
If using mike input are you using VOX or PTT?
Using PTT via CAT and K3 does key OK, just no audio seems to be TX.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
