A short jumper wire across the connector wiring points on the K60XV board would do the same as the Y adapter and be just as easy - one less connector point to cause future problems IMHO.
73, Don W3FPR > -----Original Message----- > Kent Tannery wrote: > > > I am trying to use my K2/100 (K60XV transverter interface installed) > > with a Down East Microwave 900mhz transverter which has only a > > "common" IF (not a TX IF and RX IF). The transverter requires low > > power IF around 0.10 miliwatts. (Transmitting has been tested and > > works fine) > > The problem is that the DEMI transverter has a common IF and the K2 > > has seperate TX and RX IFs. > > Kent, > > You should be able to simply use a "Y" RCA adapter to tie the > transverter IN and OUT jacks in parallel. Then route the resulting > single cable to the transverter. > > If this doesn't work, please let me know -- it should. It should also > be documented in the XV series manual. If not, it was an oversight on > my part. We'll add an errata item. > > 73, > Wayne > N6KR > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com