Mine registers anything it wants in non transmit mode, many times pegs
the swr chart, other
times 2 or 3 to 1.. normal from what I see.
Merv K9FD/KH6 WH2XCR
I did something tonight I have not done before since having my P3 TX Monitor in
place. I was testing the adjustment on my paddle in TX Test Mode and I noticed
that the P3 acted as normal — that is, no signal — with the exception of the
bar graph for SWR. The bar graph registered an SWR of 3:1 (normally about
1.1:1) in response to key down while in Test Mode. Yet, the bar graph acts
normally showing the correct SWR in TX mode (not test).
I would expect that the P3 would not register anything while in Test Mode TX —
just like before hooking up the TX Monitor.
So, this is a little anomaly that others see and is this normal behavior?
Thanks,
73, phil, K7PEH
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
