Of course in fixed-tune mode the screen always displays the same fixed
frequency range -- as you tune the K3 VFO, the cursor moves across the
screen while the displayed frequency range remains the same.
In tracking mode, you can offset VFO A to the left side of the display
using the CENTER control. (You have to have enabled the CENTER control
using the CenterEn menu item.)
Once you do that, the VFO A cursor will remain at the same position on
the display as you tune the VFO. If you have the display set up to show
(let's say) -1 kHz to +9 kHz from the VFO frequency, it will continue to
do so.
Alan
On 11/18/2015 12:36 PM, Mike Reublin NF4L wrote:
Span is set at 10. When chasing DX split, is it possible to position
the VFO A cursor at the left edge of the display and have the right 5
kHz expanded over the (almost) full screen?
In trying to achieve this, I got it so that when in tracking mode the
A VFO moves the magenta cursor as well as the A & B markers. The B
VFO also moves the magenta cursor. The green cursor doesn't move. Is
this working as intended?
73, Mike NF4L
______________________________________________________________
Elecraft mailing list Home:
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/mmfaq.htm Post:
mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this
email list: http://www.qsl.net/donate.html Message delivered to
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
