I'm not doing a a good job of explaining I think. The rig is at 3.524. I double-tap the Split button to equalize the VFOs, then hold Split. The P3 is set to a span of 10, i.e. -5 appears to the left, +5 appears to the right. I set the P3 to tracking mode and move the green cursor to the left edge of the screen.
What I'm looking for is that when I tune either the B VFO or the B marker up band, it reaches the far right edge of the screen when I get to 3.529, instead of reaching 3.529 when it gets just to the right of the screen center. In this set-up moving the B marker moves the A & B cursor and the marker and changes the center freq. displayed on the screen. That isn't desirable. I don't want to change the span, just the amount of real estate it covers. 73, Mike NF4L > On Nov 19, 2015, at 2:00 PM, Alan <[email protected]> wrote: > > Hi Mike, > > On 11/19/2015 10:17 AM, Mike Reublin NF4L wrote: >> >> So is there a way to have that almost full screen from the A cursor >> on the left edge to the right side of the screen cover 5 KHz? It sure >> would make it easier to find the sweet spot in the pileup. > > In tracking mode, if you set the span to 5 kHz and adjust the CENTER control > until the VFO A cursor is right at the left edge of the screen, then it will > display from the VFO frequency to 5 kHz above it. As you tune the VFO you > will always see 5 kHz just above the VFO frequency. > > 73, > > Alan N1AL > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
