Hi
A question on the XV calibration.
I am trying to align the XV144 using K2 with XV60 to drive the
transverter. It is the QRP K2.
When doing the alignment, there are several times need to key the
K2 at the same time to tune on the transvert decided to use the tune
on K2< TX until I press the key again. All tune aligned.
Now when I have connected a microphone to the K USB I seem to drive
the XV144 power in the r turn down the power more then half to not have the
red XV144 on. So when K2 can be less then the wanted power my
the Power setting. Is
somet
If so what signal should I then use to tune the XV144 cw or a USB
wher
Thanks in advance
OZ1BZJ
Michael Jensen
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
