Did you try resetting the passband to "normal" by doing a long press on the control?
Sent from my iPhone > On Feb 23, 2016, at 3:31 PM, Jeff Schmidt <[email protected]> wrote: > > I can no longer select low cut/high cut (vs. shift/width) in LSB/USB. > A little homework reveals that this as a known side effect of changing the > passband shift from its default. > I'm sure I must have changed the PB CTRL to .01 at some point, but I can't > seem to change it back; a firmware reload didn't help. Moving VFO A while in > config:PB CTRL gives "N/A". > > Note that this is only manifesting itself on SSB (all other modes are set to > the default of .05, and selecting hi/lo / shift/width works FB). > > S/N 7080, old synths > versions before/after firmware reload: > 5.38 1.25 2.86 2.86 1.03 > > -- > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
