Setting to “NOR” by a long press on Shift control should reset the passband, if having it off center is what’s causing your issue.
Full disclosure, I don’t use SHIFT/WIDTH on SSB, so switching between the two modes is not something I’ve done since building the radio in 2008 :-) Grant NQ5T K3 #2091, KX3 #8342 > On Feb 23, 2016, at 4:10 PM, Jeff Schmidt <[email protected]> wrote: > > Thanks, Grant, I'm not sure what you mean. > > 'shift lo' > short press shows 'FC 8 1.50' (expected when config:PB CTRL is set to .01) > long press works, I can set <--Norm-->, as does long press+left/right > (NORM1/NORM2) > > 'hi width' > short press shows 'BW 2.80' (expected when config:PB CTRL is set to .01) > long press switches between 'I' & 'II' > > Jeff > > On 2/23/2016 15:48, Grant Youngman wrote: >> Did you try resetting the passband to "normal" by doing a long press on the >> control? >> >> Sent from my iPhone >> >>> On Feb 23, 2016, at 3:31 PM, Jeff Schmidt <[email protected]> wrote: >>> >>> I can no longer select low cut/high cut (vs. shift/width) in LSB/USB. >>> A little homework reveals that this as a known side effect of changing the >>> passband shift from its default. >>> I'm sure I must have changed the PB CTRL to .01 at some point, but I can't >>> seem to change it back; a firmware reload didn't help. Moving VFO A while >>> in config:PB CTRL gives "N/A". >>> >>> Note that this is only manifesting itself on SSB (all other modes are set >>> to the default of .05, and selecting hi/lo / shift/width works FB). >>> >>> S/N 7080, old synths >>> versions before/after firmware reload: >>> 5.38 1.25 2.86 2.86 1.03 >>> >>> -- >>> > > -- > 73, > Jeff KC9WSJ > @ EN52wf ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
