Thanks, Grant, I'm not sure what you mean.
'shift lo'
short press shows 'FC 8 1.50' (expected when config:PB CTRL is set to .01)
long press works, I can set <--Norm-->, as does long press+left/right
(NORM1/NORM2)
'hi width'
short press shows 'BW 2.80' (expected when config:PB CTRL is set to .01)
long press switches between 'I' & 'II'
Jeff
On 2/23/2016 15:48, Grant Youngman wrote:
Did you try resetting the passband to "normal" by doing a long press on the
control?
Sent from my iPhone
On Feb 23, 2016, at 3:31 PM, Jeff Schmidt <[email protected]> wrote:
I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
A little homework reveals that this as a known side effect of changing the
passband shift from its default.
I'm sure I must have changed the PB CTRL to .01 at some point, but I can't seem to change
it back; a firmware reload didn't help. Moving VFO A while in config:PB CTRL gives
"N/A".
Note that this is only manifesting itself on SSB (all other modes are set to
the default of .05, and selecting hi/lo / shift/width works FB).
S/N 7080, old synths
versions before/after firmware reload:
5.38 1.25 2.86 2.86 1.03
--
--
73,
Jeff KC9WSJ
@ EN52wf
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
