Jeff,
It would appear that something is "stuck".
Do you have a saved configuration file from sometime before this problem
came up?
If so, try an EEINIT (Reset to Factory Defaults) and then restore the
configuration file.
The Reset to Factory Defaults will wipe out the calibration and
configuration data that is particular to your K3. That is why saving a
configuration file is important. K3 Utility makes it easy to save and
restore a configuration file.
Reloading the firmware will not change the configuration settings.
If you do not have a saved configuration file, you can still do the
EEINIT, but you will have to do all the calibration procedures listed in
the manual and activate whatever options you have installed in the menu.
73,
Don W3FPR
On 2/23/2016 4:31 PM, Jeff Schmidt wrote:
I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
A little homework reveals that this as a known side effect of changing
the passband shift from its default.
I'm sure I must have changed the PB CTRL to .01 at some point, but I
can't seem to change it back; a firmware reload didn't help. Moving
VFO A while in config:PB CTRL gives "N/A".
Note that this is only manifesting itself on SSB (all other modes are
set to the default of .05, and selecting hi/lo / shift/width works FB).
S/N 7080, old synths
versions before/after firmware reload:
5.38 1.25 2.86 2.86 1.03
--
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
