I would respectfully disagree with this advice. It is dependent on the
type of iron you're using. The Hakko FX-951 behaves quite different from
the traditional temperature controlled stations. It has very fast
thermal recovery, so typical through hole pads will flow in much less
than 3 seconds, but not because the iron is too hot.
73,
Josh W6XU
On 6/2/2016 8:52 AM, Don Wilhelm wrote:
It should wick out completely onto the solder pad and the component
lead in 2 to 3 seconds. If it takes longer than that the iron is too
cold, if shorter, the iron is too hot.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
