Thanks for your quick reply Dan. Logger 32 has a "Radio Debug Window" which shows the commands and replies going between Logger 32 and the K2.
When I click on a DX spot, Logger 32 sends the following message to the K2: Set Radio Freq/Mode : FR0;FA00018080000;MD3;FA00018080000; 73 de Chris, G4BUE On 13 Mar 2006 at 6:28, Dan Barker wrote: > What commands do these programs send to the K2 when you "click on a > spot"? That is the first question. If the documentation doesn't say, > and the vendor won't tell, then you'll have to put a sniffer on it. > > Only after you find a command string that has an unexpected result can > you say there is a problem with the K2. My belief is that the software > is sending commands to force the K2 out of split. > > This could be the result of an error on the part of the programmer > (unlikely) or the use of macros designed for other radios than the K2 > (most likely). > > In any case, more documentation is needed before any problem has even > been described! > > Dan / WG4S / K2 #2456 > > <snip> > when I click onto a Cluster spot, the K2 correctly > goes to the frequency and mode of the spot, but the SPLIT option is > cancelled and the K2 returns to its default setting of no SPLIT. > </snip> > > <snip>The problem must therefore be > with the design of the K2 and not the logging program. > </snip> _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com