I would say you have a software issue and not a hardware one. I have no
problems setting splits on the K2.
If the command you listed is the one for split it will not function. They
are not doing the FB so its useless.
K2 has a split button emulation "SW26" but appears they are not using this.
I am not familiar with your logger program and although its possible to use
software to do the splits, they are not getting it done without setting the
VFO B.
73,
Rich
kd0zv
----- Original Message -----
From: "Chris Page" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Monday, March 13, 2006 7:32 AM
Subject: RE: [Elecraft] K2 SPLIT AND DX CLUSTER SPOTS WITH LOGGER 32 & N1MM
Thanks for your quick reply Dan.
Logger 32 has a "Radio Debug Window" which shows the commands and
replies going between Logger 32 and the K2.
When I click on a DX spot, Logger 32 sends the following message to
the K2:
Set Radio Freq/Mode : FR0;FA00018080000;MD3;FA00018080000;
73 de Chris, G4BUE
On 13 Mar 2006 at 6:28, Dan Barker wrote:
What commands do these programs send to the K2 when you "click on a
spot"? That is the first question. If the documentation doesn't say,
and the vendor won't tell, then you'll have to put a sniffer on it.
Only after you find a command string that has an unexpected result can
you say there is a problem with the K2. My belief is that the software
is sending commands to force the K2 out of split.
This could be the result of an error on the part of the programmer
(unlikely) or the use of macros designed for other radios than the K2
(most likely).
In any case, more documentation is needed before any problem has even
been described!
Dan / WG4S / K2 #2456
<snip>
when I click onto a Cluster spot, the K2 correctly
goes to the frequency and mode of the spot, but the SPLIT option is
cancelled and the K2 returns to its default setting of no SPLIT.
</snip>
<snip>The problem must therefore be
with the design of the K2 and not the logging program.
</snip>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
