Hi, I’m very new to Elecraft and K3S so hope this is not too obvious….
I have a K3S connected to my PC with audio tones coming in via MIC IN (in reality the K3S is the remote end of a K3-Twin remote setup). When I use DATA-A sub mode for CW, the transmission is 600Hz higher than the VFO frequency. I assume this is because DATA-A transmits on the USB and the VFO shows the suppressed carrier frequency? I want my CW signal to match the VFO, how can I do that? 73, Graham VK3GA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
