I have read some emails concerning the RS-232 connector on the KXPA100's back panel not working with software applications that need the rig's data, but I did not see any resolution. In my case, I just set up a ciro mazzoni midi loop. This loop will follow the radio's frequency, getting data from the rig. Unfortunately, the loop's control box only works automatically when the the RS-232 connector from the control box is hooked directly to the KX3's side panel, meaning I can only run 10 watts. BTW, there is a slight delay in setting the frequency, but loop works pretty nicely. However, it will not work when plugged into the RS-232 connector on the KXPA100's back panel. If it makes any difference, the loop control box uses a DB9, so I am using the KXSER (3.5mm to DB9-F) Cable. Hopefully, someone on this list has not only encountered this problem but has a remedy. Thanks in advance. Tom W2CRN
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
