Tom,
Do you have the KX3 to KXPA100 adapter cable plugged as indicated on
page 14 of the KXPA100 manual? If so, make certain the RJ-45 plugs are
fully inserted - you should hear a slight click when they are fully
mated. If there is any doubt about them seating, pull back the boot on
the RJ-45 cable end and push the inside connector body "home".
73,
Don W3FPR
On 11/4/2016 9:37 AM, Thomas Beltran wrote:
I have read some emails concerning the RS-232 connector on the KXPA100's
back panel not working with software applications that need the rig's data,
but I did not see any resolution. In my case, I just set up a ciro mazzoni
midi loop. This loop will follow the radio's frequency, getting data from
the rig. Unfortunately, the loop's control box only works automatically
when the the RS-232 connector from the control box is hooked directly to the
KX3's side panel, meaning I can only run 10 watts. BTW, there is a slight
delay in setting the frequency, but loop works pretty nicely. However, it
will not work when plugged into the RS-232 connector on the KXPA100's back
panel. If it makes any difference, the loop control box uses a DB9, so I
am using the KXSER (3.5mm to DB9-F) Cable. Hopefully, someone on this list
has not only encountered this problem but has a remedy. Thanks in advance.
Tom W2CRN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
