Set all to 38400. Sent from my iPhone ...nr4c. bill
> On Nov 4, 2016, at 10:34 AM, Thomas Beltran <[email protected]> wrote: > > Hello John and thanks. Should I figure out what the baud rate of the kx3 is > (since that works) and then set the kxpa100 to match? > > -----Original Message----- > From: Elecraft [mailto:[email protected]] On Behalf Of John > Pitz > Sent: Friday, November 04, 2016 7:23 AM > To: [email protected] > Subject: Re: [Elecraft] KXPA100 RS-232 problem > > It is likely a RS232 speed issue like Dick Dievendorff said. Something else > you may want to do is change the KX3 baud rate to match the KXPA100. The > KXPA100 doesn't care what the baud rate of the KX3 is and will auto detect > it. This way you will be able to seamlessly use the > KX3 by itself if for some reason you don't want or need the amp. > > >> On Fri, 2016-11-04 at 06:37 -0700, Thomas Beltran wrote: >> >> I have read some emails concerning the RS-232 connector on the >> KXPA100's back panel not working with software applications that need >> the rig's data, but I did not see any resolution. In my case, I just >> set up a ciro mazzoni midi loop. This loop will follow the radio's >> frequency, getting data from the rig. Unfortunately, the loop's >> control box only works automatically when the the RS-232 connector >> from the control box is hooked directly to the KX3's side panel, >> meaning I can only run 10 watts. BTW, there is a slight delay in >> setting the frequency, but loop works pretty nicely. However, it will not > work when plugged into the RS-232 connector on the KXPA100's back >> panel. If it makes any difference, the loop control box uses a DB9, so > I >> am using the KXSER (3.5mm to DB9-F) Cable. Hopefully, someone on this >> list has not only encountered this problem but has a remedy. Thanks in > advance. >> Tom W2CRN >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net Please help support this email >> list: http://www.qsl.net/donate.html Message delivered to >> [email protected] >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html Message > delivered to [email protected] > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
