Fantastic!! Thanks, Wayne & co. Now, could you provide extended TX audio bandwidth on the K3/K3S also? It would be good to have it as a proper “feature" .. :-)
Grant NQ5T K3 #2091, KX3 #8342 > On Feb 17, 2017, at 9:05 PM, Wayne Burdick <[email protected]> wrote: > > Hi all, > > Beta firmware rev. 2.70 is now available on our KX3 software page. See > release notes below for details. > > For instructions on installing beta releases, refer to our KX3 software page. > (Beta releases are not automatically recognized by KX3 Utility.) > > 73, > Wayne > N6KR > > * * * > > > MCU 2.70 / DSP 1.49, 2-17-2017 > > * AM TX BANDWIDTH INCREASED: The AM transmit bandwidth is now approximately > 100-4000 Hz (was 100-3000). TX EQ can be used to further shape the passband. > > * AM TX ALC IMPROVEMENTS: Fixed a bug in the AM power-control algorithm that > was causing power output to start too high, then decrease over time when the > operator is speaking. In addition, peak power output is now displayed, rather > than power/4 (25%). This is intended to make the operator aware of the actual > output from the radio, which accounts for the observed current drain, stress > on dummy loads or antennas, etc. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
