Sorry, Aaron, I wasn't clear. I'm talking about the freq displays on the PX3, not on the KX3. RATE/KHz only effects the KX3 display and works fine.
/Rick On Tue, Feb 21, 2017 at 5:14 PM, Aaron Marroquin <[email protected]> wrote: > I have tended to use the RATE/KHZ button to change the dial speed/display > resolution when tuning around. > > On Tue, Feb 21, 2017 at 5:10 PM Rick Tavan <[email protected]> wrote: > >> I was several releases back and just installed this beta so my question >> probably applies to an earlier release. >> >> I was dismayed to see that frequency display resolution (all 3 of them) is >> now down to the the single Hz! That's three decimal places. I always >> thought two decimal places was too many, given the typical resolution of >> the display. Is there a way to truncate this, say to the nearest one KHz? >> Even the P3 only goes down to hundreds of Hz. This is a radio, not a >> laboratory instrument! >> >> 73, >> >> /Rick N6XI >> >> On Sun, Feb 19, 2017 at 10:20 AM, Edouard Lafargue [email protected] >> [KX3] <[email protected]> wrote: >> >> > >> > >> > Excellent news, Wayne! >> > >> > If only you could consider making the "Mic Btn" settings >> mode-dependent, >> > my life would be complete (or thereabouts). Right now this is the #1 >> > setting I need to change all the time: when using the Mic on SSB I have >> to >> > enable "Ptt", and when switching to DATA to connect my audio card for >> > digital modes I need to set it to "Off" because the audio card jack I >> use >> > keys PTT... :) >> > >> > 73 de ed w6ela >> > >> > On Fri, Feb 17, 2017 at 6:05 PM, Wayne Burdick <[email protected]> >> wrote: >> > >> >> Hi all, >> >> >> >> Beta firmware rev. 2.70 is now available on our KX3 software page. See >> >> release notes below for details. >> >> >> >> For instructions on installing beta releases, refer to our KX3 software >> >> page. (Beta releases are not automatically recognized by KX3 Utility.) >> >> >> >> 73, >> >> Wayne >> >> N6KR >> >> >> >> * * * >> >> >> >> >> >> MCU 2.70 / DSP 1.49, 2-17-2017 >> >> >> >> * AM TX BANDWIDTH INCREASED: The AM transmit bandwidth is now >> >> approximately 100-4000 Hz (was 100-3000). TX EQ can be used to further >> >> shape the passband. >> >> >> >> * AM TX ALC IMPROVEMENTS: Fixed a bug in the AM power-control algorithm >> >> that was causing power output to start too high, then decrease over >> time >> >> when the operator is speaking. In addition, peak power output is now >> >> displayed, rather than power/4 (25%). This is intended to make the >> operator >> >> aware of the actual output from the radio, which accounts for the >> observed >> >> current drain, stress on dummy loads or antennas, etc. >> >> >> >> * SCANNING WORKS WITH FREQUENCIES BELOW 1.0 MHz. Previously, scanning >> >> would stall in this case. >> >> >> >> For software developers: >> >> >> >> * DT, FR, and FT HOST COMMANDS DISALLOWED IN TX MODE: Previously, these >> >> commands (data submode, unsplit, and split) could be sent to the K3 >> during >> >> transmit from software applications. This could sometimes cause side >> >> effects such as muting of transmit audio in DATA modes. >> >> >> >> * RIT CLEAR SWITCH UPDATES RIT OFFSET AT PX3 PANADAPTER. >> >> >> >> * POWER-OUTPUT CONTROL COMMAND (“PC”) FIXED: The PC command now >> correctly >> >> handles the KX3’s power ranges (up to 12 W or 15 W depending on band). >> >> >> >> * PSK31/PSK63 SELECTION (ETC.) VIA REMOTE COMMAND: When the DATA >> submode >> >> is being modified under remote control, a software application can now >> >> select between PSK31/PSK63 using the UP/DN control commands. Similarly, >> >> UPB/DNB can be used to select the desired TEXT decode mode (DEC OFF, TX >> >> ONLY, RX THRn). To determine the current state of any of these >> parameters, >> >> use the DS or DB commands. Refer to the Programmer’s Reference. >> >> >> >> ______________________________________________________________ >> >> Elecraft mailing list >> >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> >> Help: http://mailman.qth.net/mmfaq.htm >> >> Post: mailto:[email protected] >> >> >> >> This list hosted by: http://www.qsl.net >> >> Please help support this email list: http://www.qsl.net/donate.html >> >> Message delivered to [email protected] >> >> >> > >> > __._,_.___ >> > ------------------------------ >> > Posted by: Edouard Lafargue <[email protected]> >> > ------------------------------ >> > Reply via web post >> > <https://groups.yahoo.com/neo/groups/KX3/conversations/ >> messages/61225;_ylc=X3oDMTJyajdtOG5iBF9TAzk3MzU5Nz >> E0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARtc2dJZAM2MT >> IyNQRzZWMDZnRyBHNsawNycGx5BHN0aW1lAzE0ODc1Mjg0NTI-?act= >> reply&messageNum=61225> >> > • Reply to sender >> > <[email protected]?subject=Re%3A%20%5BElecraft% >> 5D%20New%20KX3%20Beta%20Firmware%2C%20rev%2E%202%2E70%3A%20Various% >> 20improvements> >> > • Reply to group >> > <[email protected]?subject=Re%3A%20%5BElecraft%5D%20New% >> 20KX3%20Beta%20Firmware%2C%20rev%2E%202%2E70%3A%20Various%20improvements> >> > • Start a New Topic >> > <https://groups.yahoo.com/neo/groups/KX3/conversations/newtopic;_ylc= >> X3oDMTJma2ZxdWo3BF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNw >> SWQDMTcwNTA2MzEwOARzZWMDZnRyBHNsawNudHBjBHN0aW1lAzE0ODc1Mjg0NTI-> >> > • Messages in this topic >> > <https://groups.yahoo.com/neo/groups/KX3/conversations/ >> topics/61206;_ylc=X3oDMTM3bjYzdGdnBF9TAzk3MzU5Nz >> E0BGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARtc2dJZAM2MT >> IyNQRzZWMDZnRyBHNsawN2dHBjBHN0aW1lAzE0ODc1Mjg0NTIEdHBjSWQDNjEyMDY-> >> > (2) >> > ------------------------------ >> > Have you tried the highest rated email app? <https://yho.com/1wwmgg> >> > With 4.5 stars in iTunes, the Yahoo Mail app is the highest rated email >> > app on the market. What are you waiting for? Now you can access all your >> > inboxes (Gmail, Outlook, AOL and more) in one place. Never delete an >> email >> > again with 1000GB of free cloud storage. >> > ------------------------------ >> > Visit Your Group >> > <https://groups.yahoo.com/neo/groups/KX3/info;_ylc= >> X3oDMTJma2ZybHRtBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNw >> SWQDMTcwNTA2MzEwOARzZWMDdnRsBHNsawN2Z2hwBHN0aW1lAzE0ODc1Mjg0NTI-> >> > >> > - New Members >> > <https://groups.yahoo.com/neo/groups/KX3/members/all;_ylc= >> X3oDMTJncDlucTUzBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNw >> SWQDMTcwNTA2MzEwOARzZWMDdnRsBHNsawN2bWJycwRzdGltZQMxNDg3NTI4NDUy> >> > 12 >> > - New Photos >> > <https://groups.yahoo.com/neo/groups/KX3/photos/photostream;_ylc= >> X3oDMTJnNDYxNnVrBF9TAzk3MzU5NzE0BGdycElkAzc0NTIwOTQ3BGdycHNw >> SWQDMTcwNTA2MzEwOARzZWMDdnRsBHNsawN2cGhvdARzdGltZQMxNDg3NTI4NDUy> >> > 1 >> > >> > [image: Yahoo! Groups] >> > <https://groups.yahoo.com/neo;_ylc=X3oDMTJlM2JqbXZhBF9TAzk3NDc2NT >> kwBGdycElkAzc0NTIwOTQ3BGdycHNwSWQDMTcwNTA2MzEwOARzZWMDZnRyBH >> NsawNnZnAEc3RpbWUDMTQ4NzUyODQ1Mg--> >> > • Privacy <https://info.yahoo.com/privacy/us/yahoo/groups/details.html> >> • >> > Unsubscribe <[email protected]?subject=Unsubscribe> • >> Terms >> > of Use <https://info.yahoo.com/legal/us/yahoo/utos/terms/> >> > >> > . >> > >> > __,_._,___ >> > >> >> >> >> -- >> >> Rick Tavan >> Truckee, CA >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > > -- > > Thank you, > > Aaron M. Marroquin > (707) 540-4446 > -- Rick Tavan Truckee, CA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
