Make sure VOX is turned ON on the K3S. 73, Victor, 4X6GP Rehovot, Israel Formerly K2VCO http://www.qsl.net/k2vco/
On 15 May 2017 16:20, Trevor Clapp wrote:
When I am using the K3S with an external transverter which uses the key out line to change from RX to TX i am finding that with a paddle input from my Winkeyer I cannot get the transverter to remain keyed. Adjusting the CW delay does not increase the time btween keying and the relay in the transverter clicking out. So basically I get the relay clicking on every keyed letter. I have dried full and semi break in with no difference. I do not have the same situation on the KX3 , but then I am not using an external transverter, and wondered if there was another setting somewhere that I should be looking at. 2EØLDZ Trevor Clapp M. 07900 49 77 11
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
