I forgot to add: and make sure the KEY OUT line is connected to the
transverter, and the transverter is configured to use it. It seems like
the transverter is sensing RF rather than using the K3S Key Out line.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
http://www.qsl.net/k2vco/
On 15 May 2017 16:58, Victor Rosenthal 4X6GP wrote:
Make sure VOX is turned ON on the K3S.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
http://www.qsl.net/k2vco/
On 15 May 2017 16:20, Trevor Clapp wrote:
When I am using the K3S with an external transverter which uses the
key out line to change from RX to TX i am finding that with a paddle
input from my Winkeyer I cannot get the transverter to remain keyed.
Adjusting the CW delay does not increase the time btween keying and
the relay in the transverter clicking out. So basically I get the
relay clicking on every keyed letter.
I have dried full and semi break in with no difference.
I do not have the same situation on the KX3 , but then I am not using
an external transverter, and wondered if there was another setting
somewhere that I should be looking at.
2EØLDZ Trevor Clapp M. 07900 49 77 11
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
