For those using WSJT-X, sometimes I find the K3s is locked as transmit but there is no RF being sent and no Rx from the K3.
Looking at the P3 I see a jitter on the upper half of the screen as if there was a tiny output but no Rf is seen on any of the three SWR meters in line (K3s, AP3 & LP-100A). I couldn't get WSJT to receive, looked at the settings, all were correct and as is sometimes needed with WSJT-X, I rebooted to get it to work properly but it still did not lock onto the K3s frequency. Rebooted again and then I realized the K3s was in that TX condition with both the red & yellow LEDs lit and that jitter on the P3 upper screen. This happens every so often and what I have to do is touch any of the buttons on the K3s and it disengages this situation. I did that to deal with the issue I mentioned above. I could restart the K3s but then I'd have to restart LP-Bridge and wait, so I use the quick fix. Anyone experience this and figure out how to prevent it? Thanks! 73, Gary KA1J ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
