Don,
That may be part of the problem. I did the CAL FIL and then the CAL
PLL failed. Since I had just started setting this up I felt I wouldn't lose
much by powering up with 4, 5, and 6 depressed abd haven't gone back to do
it again. This may be why the frequency doesn't change (no lookup tables).
John [K7SVV]
On 4/30/06, Don Wilhelm <[EMAIL PROTECTED]> wrote:
Carel,
You8 did not specify, so I must ask -- did you alos do CAL FIL before you
checked the result. It is necessary that you do both CAL PLL and CAL FIL
(for each BFO) after adjusting the refcerence oscillator.
73,
Don W3FPR
> -----Original Message-----
>
> Seems that something strange is going on with my K2 (-:
> Reading through the responses it strengthened my feeling I did
> the procedure
> (as described by Wayne, n6kr getting an exact difference of 10.000 MHz
> between tp1 and tp2) correct. But my readout is still approx 1 KHz off.
>
> Will give it another go (-:
>
> 73's,
> Carel.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--
John [K7SVV]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
