"No power to tune anything." Does this mean you've only tried to tune,
and haven't tried actually transmitting cw or phone? If so, and I don't
know how it would have changed, have you checked the Menu-Config-TUN PWR
to see what it is set to? If it is set to .1 it will show 0.0
73, Dennis NJ6G
On 8/14/2018 17:19, Don Roberts via Elecraft wrote:
I have enjoyed the wisdom of this group and have learned so much but now it is
my time to ask for help. My K3 is showing no power out. I have the K line. The
relay clicks when going from 11 to 12 watts. I can set the power up to 110, but
when I hit tune I get zere watts shown and verified by my watt meters. Makes no
difference of mode, band, dummy load, resonant ant, or multiband hex beam, 80
meter horizontal loop, or 40 meter vertical. There is no output to tune
anything.
My last contacts showed no problems. Worked 10 meter cw, 20 and 6 meter ssb ok
just two days ago. It seems to be receiving fine. The P3 display is normal,
the KAT 500 and KPA 500 change bands with the K3 as they normally do. I have
rebooted the K3 several times and have killed the master AC power to everything
only to bring it up to the same thing. The ALC, compression, mic gain all
register correct, where I always run them. I have checked to make sure the Test
button has not been ingaged. Press XMIT and all I get is 0 W. I am sure I have
forgotten something simple. Would appreciate any help. Thanks
73, Don W4CBS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
