Don - If this was suggested before, I missed it and apologize for the redundancy. Has the rig inadvertently been put into the test mode? If the TX indicator under the VFO A box is blinking, that would explain the symptoms.
Dave - K9FN On Wed, Aug 15, 2018 at 12:30 AM Don Roberts via Elecraft < elecraft@mailman.qth.net> wrote: > Yes I can set it at 35 watts which is what I usually use to drive the KPA > 500, and speak in the mic for ssb and get no power out. In cw at the same > 35 watts, when I send code either straight key or padfle. 0 watts out. Same > results if I attempt to run bearfoot at 100 watts or 5 watts, I get no > power out. Receive is working fine, the P3 is working normal, and the KPA > 500 and KAT 500 track bands as I change them. > I will try again tomorrow after a night of sleep. If still no go, will > phone home to Elecraft > Don, W4CBS > > Sent from Yahoo Mail on Android > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to dpbu...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com