From the "Troubleshooting" section of the K3 manual: *No power output*: You may have routed RF through the KXV3’s XVTR IN/OUT jacks, either by switching to a transverter band, or by setting CONFIG:KXV3 to TEST. Also try redoing TX GAIN cal (pg. 49).
73, Bob, N6TV On Tue, Aug 14, 2018 at 9:29 PM, Don Roberts via Elecraft < elecraft@mailman.qth.net> wrote: > Yes I can set it at 35 watts which is what I usually use to drive the KPA > 500, and speak in the mic for ssb and get no power out. In cw at the same > 35 watts, when I send code either straight key or padfle. 0 watts out. Same > results if I attempt to run bearfoot at 100 watts or 5 watts, I get no > power out. Receive is working fine, the P3 is working normal, and the KPA > 500 and KAT 500 track bands as I change them. > I will try again tomorrow after a night of sleep. If still no go, will > phone home to Elecraft > Don, W4CBS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com