Are you using DATA A for most daata modes and AFSK A for RTTY? Have you made sure there is *nothing* connected to the Line In jack? Have you confirmed that MENU:MIC+LINE = OFF? *AFTER* selecting DATA A/FSK A have you set MENU:MIC SEL = Line In? *AFTER* selecting DATA A/AFSK A have you adjusted the mic gain for *FOUR BARS* of ALC? The Mic Gain control is "overloaded." The Line In defaults to *0* and can not be adjusted until you have selected DATA A/AFSK A. Finally, in AFSK A if CONFIG:AFSK TX = FIL ON, make sure that the MARK frequency in MMTTY is the same as PITCH and do not tune by "clicking in the waterfall". 73, ... Joe, W4TV On 2019-03-12 11:23 AM, JAY wrote:
I have the KI03BU installed.No problem RX but unable to TX. I know there has to be some settings I am missing. This was installed at Elecraft.
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
