Thanks so much for the info I will be trying it and other suggestions soon.
On Tue, Mar 12, 2019 at 2:18 PM Joe Subich, W4TV <[email protected]> wrote: > > Are you using DATA A for most daata modes and AFSK A for RTTY? > > Have you made sure there is *nothing* connected to the Line In jack? > > Have you confirmed that MENU:MIC+LINE = OFF? > > *AFTER* selecting DATA A/FSK A have you set MENU:MIC SEL = Line In? > > *AFTER* selecting DATA A/AFSK A have you adjusted the mic gain for > *FOUR BARS* of ALC? The Mic Gain control is "overloaded." The > Line In defaults to *0* and can not be adjusted until you have > selected DATA A/AFSK A. > > Finally, in AFSK A if CONFIG:AFSK TX = FIL ON, make sure that the > MARK frequency in MMTTY is the same as PITCH and do not tune by > "clicking in the waterfall". > > 73, > > ... Joe, W4TV > > > On 2019-03-12 11:23 AM, JAY wrote: > > I have the KI03BU installed.No problem RX but unable to TX. I know there > > has to be some settings I am missing. > > This was installed at Elecraft. > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- 73 KI4TXP JAY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
