Works for me too. Latest F/W installed.
Wes
On 9/22/2019 4:17 PM, David Box wrote:
VXn works for me, don't remember the firmware change that activated the set
feature about a year ago.
de Dave K5MWR
On September 22, 2019 4:30:54 PM MDT, Don Wilhelm <[email protected]>
wrote:
George,
The VX command is "GET" only, so you can determine the VOX status, but
you cannot SET it.
See the K3 Programmer's Reference Manual.
73,
Don W3FPR
On 9/22/2019 6:16 PM, Kidder, George wrote:
GE all,
I recently tried to incorporate the VX command into some macros for
my
older K3. With the K3 utility connected directly to Com1, the VXn
command has no effect on the VOX state, although other commands work
as
expected. I run the VOX on AUTO OFF (CW WT tap 5) to avoid startup
problems, but returning to NOR has no effect. Is this a known bug or
a
single-unit flaw. Any others have this experience?
I can certainly live without this feature - I have for nearly a
decade,
but it would be nice to have it in some macros.
George, W3HBM
Bar Harbor, ME
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
