Tony,
Look at the CONFIG Menu description in the manual.
Turn CONFIG:PWR SET to Per Band and then with the AMP on, go to each
band and set the proper power to drive the amp on that band.
With the AMP off, you should have full range of the Power control.
Yes, you need the AUX cable so the K3 knows the state of the amplifier.
If you have the KAT500 as well, you will need 2 AUX cables.
73,
Don W3FPR
On 3/6/2020 2:07 PM, Tony wrote:
Tony, The Config Menu has a Per-Band power setting (PWR SET = PEr
bAnd) that will set the power output depending on the band selected.
If you use the Aux cable between the K3 and KPA500 is is fully
automatic and seamless. 73 George AI4VZ
George:
I must be missing something because when I select PER BAND in the config
menu, there's no power setting to set.
It doesn't display the power like TUN PWR does where the tune power is
shown within that menu item so you can adjust it.
I have to order the AUX cable, but in the meantime I'd like to use this
setting with the K3S so any suggestions would be appreciated.
Tony
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
