Christophe,
I forgot to mention,
Before attempting to adjust the C1 null, first pre-set R26 and R27 to
43k ohms. Measure R26 from U5 pin 5 to ground and R27 at U5 pin 3 to
ground.
Then go through the nulling process followed by the power setting
process that I outlined in my prior email.
73,
Don W3FPR
On 4/9/2020 3:25 PM, Christophe aufacf wrote:
Good morning all ,
Zero adjustment of SWR bridge (C1) page 48
as you see on the video , I set the K2 to 5Watts
https://we.tl/t-MOz5AX1v3l
I managed to adjust the SWR the K2 announces my power at 0.1 Watts !!
the consumption goes from 0.32 Amps in Rx, in Tune mode 0.5 amps
I should have 5 Watts
Thank you for your help
# K2 7369 - kpa 100 in progress
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
