Thanks for the update and glad you got it resolved. Sent from my iPhone ...nr4c. bill
> On May 23, 2020, at 12:07 AM, Madison Jones <[email protected]> wrote: > > > Thanks, Mike WØVTT, the problem is resolved! Mike asked if I had checked the > firmware, which I had previously and had determined earlier that I had the > latest version [05.67]. Thinking it couldn't hurt to reinstall it anyway, I > did, and that solved all issues! Now everything works as it should. > > Thanks to all who spent time and effort trying to get to the solution. Dunno > what the problem was, but since it is all electronic stuff, anything could > have gone wrong. > > 73 > > Madison > W5MJ > >> On Fri, May 22, 2020 at 9:42 PM Nr4c <[email protected]> wrote: >> “MODE”? >> >> Sent from my iPhone >> ...nr4c. bill >> >> >> > On May 22, 2020, at 10:23 PM, Madison Jones <[email protected]> wrote: >> > >> > Hi Don >> > >> > I checked VOX, and it is on and has been on. I tried the paddles in the key >> > jack of the K3. Nothing happens. I tried in the paddle jack of the K3. >> > Nothing happens. However, the paddles, with or without MORTTY, and with and >> > without N1MM, work fine in the Kenwood TS480 in both the key jack and the >> > paddle jack. >> > >> > I conclude, therefore, that the paddles are functional, that MORTTY is >> > functional, and that N1MM is functional. The K3 is NOT functional. Since >> > this is the Elecraft forum, I am asking that perhaps someone on the >> > reflector has a new idea since I am out of old ideas. >> > >> > Anyone else? >> > >> > Madison >> > W5MJ >> > >> >> On Fri, May 22, 2020 at 6:43 PM Don Wilhelm <[email protected]> >> >> wrote: >> >> >> >> Madison, >> >> >> >> Eliminate everything except the K3 and your paddles. >> >> >> >> Plug the paddles into the paddle jack on the K3 - does the K3 make CW? >> >> Then plug the paddles (assuming you do not have a straight key) into the >> >> KEY jack. Do you have a 'straight key' on one side of the paddles?. >> >> If both those conditions are OK, then the K3 is OK. >> >> Look to a problem with MORTTY or your computer application. >> >> >> >> Once you have identified the source of the problem, then you can address >> >> it with the appropriate forum for that particular piece of the puzzle. >> >> If it is the K3 that is misbehaving, then email [email protected] for >> >> assistance. >> >> >> >> 73, >> >> Don W3FPR >> >> >> >>> On 5/22/2020 6:25 PM, Madison Jones wrote: >> >>> Thanks to everyone. The entire configuration which I described has worked ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
