1) Are you changing bands on the rig or by using N1MM+?
a) If "rig" - Data Mode is stored by band. Change it on each band.
b) If "N1MM+" - be sure to set "Digital Modes" to AFSK
Second, the K3 is staying in Transmit after the RTTY message is
finished. I usually have to press the XMIT button to return to
receive.
Assuming this is with N1MM+ - set the rig port to allow Command PTT for
digital and make sure all your messages end with the command to return
to receive (%E or %R - I'm not sure and not in front of N1MM).
73,
... Joe, W4TV
On 2020-06-19 12:04 PM, John Reilly wrote:
I've recently changed from FSK to AFSK, and having issues. FWIW, I am
using N1MM with 2Tone as my RTTY interface, with the K3 internal sound
card.
First, When I go to DATA MD, it is always set to FSK D. I reset it to
AFSK A and it works; however, if I change bands, it resets itself to FSK
D. The AFSK A setting does not "stick" - is there a way to make the K3
remember this setting?
Second, the K3 is staying in Transmit after the RTTY message is
finished. I usually have to press the XMIT button to return to receive.
I do not have anything setup in the 2Tone PTT box, which I suspect is
the problem. I tried to use the serial DTR, but 2Tone was unable to use
the serial port that N1MM was using. I also tried VOX, but did not see a
difference. Any suggestions for setting up AFSK PTT?
Thanks,
- 73, John, N0TA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
