Here are the solutions to my questions:
1. FSK/AFSK Mode - The solution was to set the RTTY mode in N1MM to AFSK
2. Intermittent failure to go to receive after transmit: There are at
least three ways to setup the K3 and N1MM for RTTY AFSK PTT:
a. Use Serial RTS for PTT
b. Use "PTT via Radio Command Digital Mode"
c. Use VOX
Note that you cannot use more than one of these at a time. FWIW, my RTTY
N1MM macros do have {RX} at the end of each line.
The first two did not solve my problem -- I still failed to return to RX
about a third of the time; however, VOX appears to have fixed the
problem. I wish I knew why the first two don't work.
This is probably applicable to WSJTx PTT, too.
Thanks to those who replied,
- 73, John, N0TA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
