Thanks Don - I might just do that. I hadn't checked the settings before I removed the board. Good to know. In the meantime the KAT2 runs great.
On Sat, Feb 19, 2022 at 9:30 PM Don Wilhelm <d...@w3fpr.com> wrote: > Andrew, > > Bypass is not "OFF", so yes it could still be in-circuit. > The only way to really find out is to re-install it and set everything > to default. > A good exercise for a rainy/snowy afternoon. > > 73, > Don W3FPR > > On 2/19/2022 9:04 PM, Andrew Moore wrote: > > Hi Don - thanks for the suggestion. Any idea if the scratchy audio > > would persist if the KDSP2 was put into bypass mode? I tried that and > > scratchy audio was still there. > > > > Thanks, > > -Andrew > > > > > > On Sat, Feb 19, 2022 at 8:49 PM Don Wilhelm <d...@w3fpr.com> wrote: > > > > Andrew, > > > > That sounds like you had the NB and/or NR set on in the KDSP2 with > > aggressive settings. > > If the settings were aggressive, it would give you 'scratchy' audio - > > but it does eliminate other unwanted signal sounds. You might > > want to > > put the KDSP2 in again and try several settings - see the KDSP2 > > manual. > > Start with all settings at default and go from there. > > > > 73, > > Don W3FPR > > > > On 2/17/2022 3:55 PM, Andrew Moore wrote: > > > I replaced the KDSP2 with a newly built KAF2 today and am happy > > to report > > > the noise is gone. Not sure if the board swap had anything to do > > with it, > > > but everything sounds great now and hope that continues. > > > > > > Thanks, > > > -Andrew / NV1B > > > > > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
