The firmware has not been written yet for the 1PPM TCXO3-1 table calibration, so use one of the other two methods for now. It will still be more stable than the standard TCXO3. QRX for a future firmware release to do the table entry.
73, Ed - W0YK > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Sanger, Joseph > Sent: Saturday, 01 December, 2007 13:11 > To: [email protected] > Subject: RE: [Elecraft] K3 Calibration Problem > > I am trying to perform the Ref Oscillator Calibration for my 1 ppm > device: > > > Method 3 (1 ppm TCXO Option): > > * Locate the CONFIG:REF CAL menu entry. Tap 1 to change the > name to REF xxC. > > * Locate the calibration data sheet, which shows frequency vs. > temperature over a wide range. > > * For each data point, tap 2 or 3 to select the calibration > temperature, then use VFO A to set the specified oscillator > frequency in Hz. > > > and am getting nowhere fast. In step 1, I see the 'REF CAL' > menu displayed by VFO B, but tapping '1' doesn't change the > name off the menu; it merely performs the usual 'tap' > function of that switch: A/B. > > > Thanks for any help from anyone! > > ------------------------------------------------------------ > This email message, including any attachments, is for the > sole use of the intended recipient(s) and may contain > information that is proprietary, confidential, and exempt > from disclosure under applicable law. Any unauthorized > review, use, disclosure, or distribution is prohibited. If > you have received this email in error please notify the > sender by return email and delete the original message. > Please note, the recipient should check this email and any > attachments for the presence of viruses. The organization > accepts no liability for any damage caused by any virus > transmitted by this email. > ================================= > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
