The book says: "Store this setting in any memory (using the S T O R E switch), but instead of tapping the switch for the desired memory, hold the numbered switch (0 -9 ) until you see S C A N on the display."
It should say: "Store this setting in any memory (using the S T O R E switch a HOLD). THEN RCL (a hold) and a number (tap to recall memory n, hold to scan from A to B of memory n). You will see S C A N on the display." It is two operations. 1. Store the limits (from vfoA to vfoB and other parameters) in a numbered memory. 2. Start a scan (done by a HOLD vs. a TAP). If you do what the book says, it will do the HOLD function of whatever number you were pressing (in my case 1 so I saw TEST and OPER). NOTE TO MANUAL MAINTAINERS: Please edit this correction. It's very rough. Also, I'm quoting Rev F, not G. hth Dan / WG4S / K2 #2456 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of David Wilburn Sent: Saturday, December 08, 2007 9:35 AM To: elecraft Subject: [Elecraft] K2 and scanning frequencies I have read through page 103 of the 'G' manual serveral times now, things do not seem to be working out. I was hoping to setup two frequencies, either in memory or with the VFOs, and scan between them. I have setup VFOA for freqA and VFOB for freqB, and then held STORE, and then selected and held a number until SCAN is displayed. If I had two frequencies in the memory for that same band, it then scanned JUST those to frequencies. If I did not have any frequencies on that band in memory, it then 'scanned' the one frequency I put it. I then did the same thing, and held down the number key until I got AF ON, and the same thing happend. If I placed the two frequencies in spots 1 and 2, and then did this, it would scan the frequencies, hopping between them. My goal is to scan everything from freqA to freqB and back, continuously. I must be missing something obvious. -- David Wilburn [EMAIL PROTECTED] K4DGW K2 S/N 5982 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
